Cord Drawn Curtain Tracks Instructions

Re attach track onto brackets and re hang curtains.

Cord drawn curtain tracks instructions.

Standard drill bits work fine on all aluminum tracks. Measure the rod s length while it is still on the wall. Once you have worked out were your track is going to go. Curtain track features and how to install.

Tension cord and tie off h. Installing your styletrack curtain track. I have fitted a metal white curtain track with cord attachments and runners but finding it very difficult to correctly hang the curtains problem overlaper runner hope you can help pulling my hair out thanks. How to thread cord on curtain rails.

Holding the cords taut push carrier 2 as far to the left as possible. Using a small bit drill pilot holes centered in the slot through the top of the track. Remove the curtains from the traverse rods so you can access the cording. Cord on overlap master carrier as original.

First you ll want to remove the curtain along with the curtain hooks from the rod and carriers. Most curtain tracks do not have the mounting holes pre drilled. Remove the curtain rod from the. To drill holes identify where the holes should be positioned and mark the track.

If unable to locate a timber stud use a suitable wall plug or toggle for hollow walls to hold your bracket. If you re removing an old cord you can untie it. Replace sliders at each end. Fitting instructions for styletrack track if installing into plaster or wallboard where possible try and pick up a timber stud.

Then remove master carrier from the track. Draw the cord until the right hand carrier 1 is as far to the right as possible. Then feed cord around and over the top pulley g pass cord back through ovelrap master slide. Add those two.

2 pull track apart at the centre. Place pulley 2 onto track section and secure with screws. Click here for how to mend it. Hook cord over the lug on carrier 2 to secure it.

Pass the cord over the central bridge on slave master slide f twist cord to create a loop and hook over centre tab f pass cord over the top of the bottom pulley in opposite end pulley. Next place the rod face down on a flat surface. 8conversion to one way draw right hand conversion drapes drawn from left to right 1 lay track face down on the floor.